4 Replies Latest reply: Mar 27, 2015 11:46 AM by Tim Shipp RSS

    Specify LUN ALU or HLU when cloning a snapshot

    Tim Shipp Newbie
    Visibility: Open to anyone

      I want to test cloning a snapshot of a volume. I can't see any way to specify either in the GUI. I used this post to try the CLI, but I can't seem to figure out how to specify the LUN number. Any advice?

       

      Here is my command: vol --clone VOL-112 --snapname mysnapshot --clonename 112-SNAPCLONE --initiatorgrp Chassis-1 --multi_initiator yes --start_offline --lun 113

       

      TIA,

       

      Tim