implementing CS260. guide to assigning support IP address
When you use the Windows Toolkit or CLI to install the array - you will be prompted for the management IP address and the IP address for each controller (A and B). Obviously both should be on a routable VLAN
Let us know if you have any more queries
thanks Rich. Problem sorted
Abraham George Parel
kindly could you let me know if Nimble can work with Brocade VDX 6730 - switch - 16 ports - managed - rack-mountable. we have proposed a CS220G
Abraham George Parel – CEO
+27 761 052885 - <http://www.virtualworksafrica.com/> www.virtualworksafrica.com
We don't specifically have a support matrix for IP switches (unlike Fibre Channel where compatibility matrixes are essential).
We do specify some guidelines when selecting a switch. That is available on the Networking Best Practices document which is available off InfoSight.
Generally though - you should look for these qualities in your switch:
I personally haven't had too much experience with Brocade IP switches (that shouldn't be read a good or a bad thing!!) - hopefully someone can chime in on the thread to share their experience. I have seen some internal chat we've had on them and they seem good switches (just ensure you have an appropriate number of ports licenses and use brocade cables - which based on my experience would good advice to apply to HP and Cisco too !!).
Hope this helps
Retrieving data ...